TFM-6cb

Posted by Mark
Advertisements
Carver TFM-6cb

8-ohm FTC rated power/ch 65W
4-ohm FTC rated power/ch 100W
2-ohm dynamic power/ch 160W
Bridged mono power 180W
4/8-ohm FTC rated THD 0.1%
Input Impedance (Line) 30K ohms
Input Sensitivity 0.8V
Gain 29 dB
Rated full power bandwidth 20 – 20kHz
S/N-IHF A-Weighted,dB > 92 dB
Power Consumption 230 W
Dynamic Headroom 1.1 dB
Dimensions (HxWxD inches) 1.75 x 19 x 12.5
 
The modestly priced TFM-15cb and TFM-6cb share many sonic characteristics with Carver’s most expensive designs, and are often coupled with Carver’s CT-6 and CT-3 tuner/preamps in critical quality, single room music systems. These two amplifiers also serve as ideal companions to the CT-29v and C-15v in multi-room installations. Both include loop-through line level outputs for “daisy chaining” several amplifiers together, and input level controls for adjusting relative room-to-room volumes. Also, both feature a bridged mono mode for optimum performance in monophonic home-wide distributed systems, or for driving sub-woofers in home theater systems. The TFM-15cb follows the same distinctive design scheme as Carver’s high power amplifiers, including analog meters with range selection switch. Power output of 100 watts per channel (8 ohms) makes it suitable for driving many popular main listening room speakers, and it certainly has generous power reserves for driving smaller secondary room systems or rear channel surround sound speakers. The ultra-compact TFM-6cb (65W/channel into 8?) will push relatively efficient main room speakers to surprisingly high listening levels with clean, tight response. Of course, it also serves as the ideal add-on amplifier for multi-room systems and rear channel surround speakers.

PRO-PHILE Series Ultra-Thin High Headroom/Low Feedback Stereo Power Amplifier. Just 1 3/4 inches tall. Where space is at a premium, our TFM-6cb amplifier will provide an astonishing amount of power in a very small package. 65 watts per channel into 8 ohms. 100 watts per channel into 4 ohms. 130 watts per channel into 2 ohms. 180 watts bridged mono. Ideal for custom installations. Individual left/right level controls. A/B speaker switching. Power and maximum output LED’s. Additional line level output for “daisy-chaining” in multi-amp or room-to-room applications.

[phpbay keywords=”carver tfm-6cb” num=”12″ siteid=”1″ category=”293″ exclude=”manual” sortorder=”EndTimeSoonest” templatename=”default”]

Comments on 'TFM-6cb' (3)

  1. maqsood-ur-rehman says:

    I have recently changed my home sound system with CARVER: TFM-6cb power amp, Preamp/Tuner CT-24 (new) and surround processor DPL-33 from local market at Karachi. I found the system tremendously higher in performance then before. Fortunately, a German ambassador when leaving the site sold this and people in Pakistan hardly known about CARVER. I must recommend that your august concern may please be sought market in Pakistan big cities on priority basis , because the system however outdated but not going to be obsolete yet and economical to be purchased.
    wish you good luck!
    Maqsood
    Process engineer
    Oil & Gas development company – Pakistan

  2. I have a defective Carver Model TFM-15CB Power Amplifier, CLA #402645, 97570108194T that does not power up. Can you repair it or do you have a replacement? It has been dead for 5 years. My wife just left it on 24/7. It powered 3 pairs of wall mounted 8 ohm speakers located around the house, each pair of outputs ran through rheostats to adjust volume. Franklin Lacy
    northernexp@centurytel.net

  3. Ingrid says:

    Looking for a qualified repair shop as my CD player of Carver gives me “error” sign

Leave a Reply

Your email address will not be published. Required fields are marked *