TFM-35

Posted by Mark
Advertisements
8-ohm FTC rated power/ch 250 W
4-ohm FTC rated power/ch 380 W
2-ohm dynamic power/ch 560 W
Bridged mono power 700 W
4/8-ohm FTC rated THD 0.5 %
Rated full power bandwidth 20-20kHz
S/N-IHF A-Weighted,dB 98
Dimensions (HxWxD inches) 4.5x19x14.5
Comments Stereo or bridged mono
 
Simultaneous High Current/High Voltage Magnetic Field Power Amplifier. Eminently affordable and yet astonishingly powerful, the TFM-35 is designed to drive many popular speaker designs whose overall impedance fluctuations can tax conventional amp designs. Transfer Function Modified to provide the warm, natural sound of a tube amplifier. 250 watts per channel into 8 ohms. 380 watts per channel into 4 ohms. 560 watts per channel into 2 ohms. 700 watts bridged mono. Patented Magnetic Field Power Supply provides extraordinary power from a compact design. Features analog power meters with meter range switch. Concentric left/right level controls. Special circuitry to protect both the amplifier and loudspeakers from overload.

[phpbay keywords=”carver tfm-35″ num=”12″ siteid=”1″ category=”293″ exclude=”manual” sortorder=”EndTimeSoonest” templatename=”default”]

Comments on 'TFM-35' (8)

  1. Gordon says:

    I have this, I would like to send it in, have it cleaned and diagnotistic run on it, What you you charge for that and more equipment I have, Please list.

  2. Mark says:

    I’m afraid I don’t do repairs. I run the site for informational purposes.

    Try http://www.carveraudiorepair.com/

  3. Eric says:

    On the TFM-35 you refer to concentric left/right level controls. I assume that means a combined conrol for both channels? Thanks, Eric. By the way, very helpful site.

  4. Mark says:

    That’s what I get from it. One control area with two turnable knobs or a knob and a wheel.

  5. harry silver says:

    going to look at and maybe buy a tfm 35 and c3 off local CL. what should i watch
    out for? thanks. Harry

  6. steve kennedy says:

    do you know if a carver TFM-35 can handle a 4 Ohm load while bridged?

  7. Bret B says:

    Steve Kennedy in response to your question about TFM-35 handling a 4ohm load while bridged, it can I have had 2 4ohm spears hooked to it while in bridged mode at or near for volume with no problems. I do this almost ever Halloween for the neighborhood kids with music like Michael Jackson’s Thriller and more the only problem I had in the beginning was my cables my fault not the amps fault.

  8. henry says:

    I have an opportunity to purchase a used tfm aplifier. I have not been able to aquire a manual, can anyone tell me if I can run 2 pairs of speakers from this amplifier.

Leave a Reply

Your email address will not be published. Required fields are marked *