Carver TFM-15cb

8-ohm FTC rated power/ch 100W
4-ohm FTC rated power/ch 140W
2-ohm dynamic power/ch 200W
Bridged mono power 300W
4/8-ohm FTC rated THD 0.1%
Input Impedance (Line) 30K ohms
Input Sensitivity 0.7V
Gain 32 dB
Rated full power bandwidth 20 – 20kHz
S/N-IHF A-Weighted,dB > 110 dB
Power Consumption 300 W
Dynamic Headroom 1.1 dB
Dimensions (HxWxD inches) 3.6 x 19 x 13
The modestly priced TFM-15cb and TFM-6cb share many sonic characteristics with Carver’s most expensive designs, and are often coupled with Carver’s CT-6 and CT-3 tuner/preamps in critical quality, single room music systems. These two amplifiers also serve as ideal companions to the CT-29v and C-15v in multi-room installations. Both include loop-through line level outputs for “daisy chaining” several amplifiers together, and input level controls for adjusting relative room-to-room volumes. Also, both feature a bridged mono mode for optimum performance in monophonic home-wide distributed systems, or for driving sub-woofers in home theater systems. The TFM-15cb follows the same distinctive design scheme as Carver’s high power amplifiers, including analog meters with range selection switch. Power output of 100 watts per channel (8 ohms) makes it suitable for driving many popular main listening room speakers, and it certainly has generous power reserves for driving smaller secondary room systems or rear channel surround sound speakers. The ultra-compact TFM-6cb (65W/channel into 8?) will push relatively efficient main room speakers to surprisingly high listening levels with clean, tight response. Of course, it also serves as the ideal add-on amplifier for multi-room systems and rear channel surround speakers.

High Headroom/Low Feedback Stereo Power Amplifier. High power and compact size, at a very affordable price. The TFM-15cb will provide the warm, natural sound that is the hallmark of Carver in an attractive no-nonsense design. It will drive most loudspeakers to room-filling volume levels. 100 watts per channel into 8 ohms. 140 watts per channel into 4 ohms. 200 watts per channel into 2 ohms. 300 watts bridged mono. Dual analog meters with range selection. A/B speaker switching. Individual left/right level controls. Special circuitry to protect both the amplifier and loudspeakers from overload. Additional line level output for “daisy-chaining” in multi-amp or room-to-room applications.

[phpbay keywords=”carver tfm-15cb” num=”12″ siteid=”1″ category=”293″ exclude=”manual” sortorder=”EndTimeSoonest” templatename=”default”]

8 thoughts on “TFM-15cb

  1. im used this amp with carver ct 24 preamp and sounds much beter than rotel rtc-970 preamp and rb-985 amp carver has a prety clean and natural sound i love carver amp

  2. Hi!,me to i Like to know where to get OEM meter lamps for Carver CM-1090 & TX-12 (tuner) THANK YOU FOR HELP!

  3. Good Morning
    Can you direct me where I can take my TCM-15CB to be repaired in NYC.
    My cell # is 347-661-8270 Please give me call at your earliest convenience

  4. If I had a pair of TFM 15 CB Amps in bridge mode, the inputs would be hooked up to the output jacks. In this configuration, is there an output I could use for a sub out? If so, which one?

    Thank you


Leave a Reply

Your email address will not be published. Required fields are marked *