RMS does not mean continuous, it is a way of computing the power an AC waveform has that is equivilent to a DC measurement. The numbers you cited are for continuous RMS, which is … well continuous, and there is the key.

The amp can deliver 350w continuous to meet the FTC requirements for a specification, or “musical” waveforms of over 600w into an 8 ohm load.

So, now I have an un-used CARVER M-1.5t … hate to sell it, but also hate to know it’s going to waste (not being used)…

decisions decisions decisions.

The manual does state “350w RMS P/chan into 8ohm @ 1kHz. AND 500w RMS p/chan into 4ohm @ 1kHz. AND finally, 1000w RMS into 8ohms single channel,” BUT it is the specifications for
“POWER AT CLIPPING”

The manual states this as well.

POWER OUTPUT: 200w RMS P/chan into 8ohms from 20Hz to 20kHz.

I understand clipping at a novice level, so my confusion is why does it mention 4ohms on the specification sheet at all? especially under “power at clipping” when clipping is bad.

The manual later boasts this amp is “Second to None” capable of delivering more then 350w RMS p/chan @ 8ohms further clouds my understanding of Clipping. I thought RMS meant continuous…If clipping is an amp choking, and RMS is continuous….Then why under the specs “Power at clipping” does the term RMS even belong? continuous clipping ?.

LOL, I am so sorry for the ramble, but I REALLY crave knowledge. Even more for my own equipment
WHY ARE THEY CONFUSING ME!?

I do, however have a question about a recent speaker selection I’ve added to my audio arsenal.
This is a question about impedance/ohms.

I own A Carver M-1.0t and a M-0.5t. The M-1.0t has the original owner’s manual, but it has me questioning compatibility.

Here is what I need to know from you smart folks..

I purchased two speaker enclosures with DUEL 10″ Woofers. The woofers are 4ohm.

My M-1.0t manual states “350w RMS P/chan into 8ohm @ 1kHz. AND 500w RMS p/chan into 4ohm @ 1kHz. AND finally, 1000w RMS into 8ohms single channel.”

Clarification defines my need. I have always used 8ohm, but the FOUR 4ohm 10inch woofers will put the range of sound in my studio over the top!!

Can I safley use 4ohm subs on either of the two amps?
I don’t have the manual for the 0.5t, so I will assume power/wattage will be the only real difference in that respective portion of the specifications.

My preference is to run the 4ohm subs into the 0.5t. I appreciate you reading, and I hope to hear back.

Just a quick update on some info I found here…I just downloaded a manual for the PM 1.5 Amp and it is rated at 450 watts at 8 ohms and 600 watts at 4 ohms and 300 wpc at 16 ohms. I dont know if this conflicts with info that you know to be correct, but this comes directly from a PDF of the original manual. Thought you might want to update your website info. Any questions, please feel free to contact me.

regards,

Tom

Carver Repair may have that fuse cap.

This site is a fan site. Carver Corp went out of business.